Amaryllis and eHLT..

The Amaryllis is coming along pretty well.. on the verge of popping out and actually looking like a flower any day now. Check it out:

It's about 2' tall now..

Otherwise, here's some pics of the grounding ring idea I came up with, with a bit of help from my engineering team ;), to ground the electric element to the keg and thus the ground. Also, a pic or two of the JB Weld attachment of the electrical extension box to the side of the keg. This stuff is *way* stronger than I had any idea it would be. To take this off now would require a hammer and some finish work with a grinder to get the JB Weld off. It's serious stuff!

Simple. A metal flat plate with a big hole in it for the element to pass through and ground on.. 

Assembled.. 

And bottom view, with gasket on there.. 

I put a bit of JB Weld on the outside of the box, but..

..most of it is on the inside. 

Next, I did a little electrical work on the inside of the box, including fabricating up all the wires and jumpers and putting the box all together. Check out the mostly finished project:

Not so complicated after all.. 

All buttoned up. ON is UP!

Add caption

Haven't run a powered on test yet, because I discovered a small leak around the gasket yesterday when I filled it up with water.. seems there's some seepage around the main gasket that wasn't there before I installed the grounding ring thing. I may have to rethink that a bit.. I'll report back with a solution later.